Filter
Top Products
3-4
Cisco Broadband Access Center 3.8 Administrator Guide
OL-27172-01
Chapter 3 Configuration Workflows and Checklists
Technology Workflows
Preregistering Device Data in Cisco BAC
Preregistering adds the device record to the RDU before the device makes initial contact with the DPE.
The DPE is also known as the autoconfiguration server (ACS). This task is typically executed from the
provisioning API. However, you can preregister device data from the administrator user interface as
well.
To preregister device data in Cisco BAC:
Step 1 Add the device record to the RDU database by using the API or the administrator user interface.
To add a device record from the administrator user interface:
a. Choose Devices > Manage Devices.
b. On the Manage Devices page, click Add.
The Add Device page appears.
c. Enter values in the appropriate fields. The required and recommended provisioning attributes for a
preregistered device are:
c. Create a Class of Service from the
administrator user interface.
Remember to:
–
Specify the configuration template file.
–
Specify the firmware rules file.
–
Optionally, specify properties.
Configuring the Class of Service, page 17-1
2. Configure default settings for the CWMP
technology from the administrator user interface.
–
Set the default Class of Service; for example,
for unknown devices.
–
Set the Connection Request Service defaults
from any of the following pages:
Configuration > Class of Service;
Configuration > Defaults; and Devices.
Configuring Defaults, page 17-6
3. Preregister the CWMP devices. Preregistering Device Data in Cisco BAC,
page 3-4
Table 3-3 RDU Configuration Workflow (continued)
Procedure Refer to ...
Required
• Device identifier
• Registered Class of Service
• Home provisioning group
Additional Typical Attributes
Additional attributes may be required depending on customer premises equipment (CPE)
authentication methods.