Filter
Top Products
Operating Instructions Teledyne API M100E Analyzer Operation Manual
94
To access and navigate the VARS menu, use the following key sequence.
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SAMPLE* RANGE = 500.000 PPB SO2 =X.XXX
< TST TST > CAL SETUP
SETUP X.X
PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X
SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SETUP X.X 0 ) DAS_HOLD_OFF=15.0 Minutes
NEXT JUMP EDIT PRNT EXIT
SETUP X.X 1 ) TPC_ENABLE=ON
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X ENTER VARS PASS: 818
8 1 8 ENTR EXIT
SETUP X.X DAS_HOLD_OFF=15.0 Minutes
1 5 .0 ENTR EXIT
SETUP X.X 2)RCELL_SET=50.0 DegC
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X 3) IZS_SET=50.0 DegC
PREV NEXT JUMP EDIT PRNT EXIT
DO NOT change
theses set-points
unless
specifically
instructed to by
T-API Customer
Service.
SETUP X.X CLOCK_ADJ=0 Sec/Day
+ 0 0 ENTR EXIT
SETUP X.X 7) CLOCK_ADJ=0 Sec/Day
PREV NEXT JUMP EDIT PRNT EXIT
EXIT ignores the new setting.
ENTR accepts the new setting.
SETUP X.X TPC_ENABLE=ON
ON ENTR EXIT
SETUP X.X 4 ) DYN_ZERO=ON
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X DYN_ZERO=ON
ON ENTR EXIT
Toggle this keys to change setting
Toggle this keys to change setting
SETUP X.X 5) DYN_SPAN=ON
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X DYN_SPAN=ON
ON ENTR EXIT
Toggle this keys to change setting
Toggle this keys to change setting
Toggle tese keys to change setting
SETUP X.X CONC_PRECUISION : 3
AUTO 0 1 2 3 4 ENTR EXIT
SETUP X.X 6) CONC_PRECISION : 3
PREV NEXT JUMP EDIT PRNT EXIT
Toggle these keys to change setting
Figure 6-16: SETUP – VARS Menu
04515F DCN6048