Filter
Top Products
Teledyne API M100E Analyzer Operation Manual Remote Operation and Advanced Features
173
To assign or reset the status flag bit assignments, access the COMM Menu (refer to Figure 7-1), then press:
SETUP X. HESSEN STATUS FLAGS
<SET SET> EDIT EXIT
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2 EXIT
SETUP X. PMT DET WARNING: 0002
PREV NEXT EDIT PRNT EXIT
Repeat pressing SET> until …
SETUP X. SYSTEM RESET: 0000
PREV NEXT EDIT PRNT EXIT
The <CH and
CH> keys move
the [ ] cursor left
and right along
the bit string.
Repeat pressing NEXT or PREV until the desired
message flag is displayed. Refer to Table 7-15.
For Example …
ENTR key accepts the
new settings
EXIT key ignores the
new settin
g
s
SETUP X. SYSTEM RESET: [0]000
<CH CH> [0] ENTR EXIT
Press the [?] key repeatedly to cycle through the available character set: 0-9
Note: Values of A-F can also be set but are meaningless.
Figure 7-40: COMM – Status Flag Bit Assignment
7.3.4.8. INSTRUMENT ID CODE
Each instrument on a Hessen Protocol network must have a unique ID code. The M100E is programmed with a
default ID code of 100. To change this code, refer to Section 7.1.1.
04515F DCN6048