Filter
Top Products
Teledyne API M100E Analyzer Operation Manual Remote Operation and Advanced Features
171
To Select a Hessen response mode, access the COMM Menu (refer to Figure 7-1), then press:
SETUP X.X HESSEN RESPONSE MODE :CMD
<SET SET> EDIT EXIT
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2 EXIT
SETUP X.X HESSEN VARIATION: TYPE 1
SET> EDIT EXIT
SETUP X.X HESSEN RESPONSE MODE :CMD
BCC TEXT CMD ENTR EXIT
Press to
change
response
mode.
ENTR key accepts the
new settings
EXIT key ignores the
new settin
g
s
Figure 7-39: COMM – Select Hessen Protocol Response Mode
7.3.4.6. HESSEN PROTOCOL GAS ID
The M100E Analyzer is a single gas instrument that measures SO
2
. As such, its default gas ID has already been
set to 110. There is no need to change this setting.
7.3.4.7. SETTING HESSEN PROTOCOL STATUS FLAGS
Teledyne API’s implementation of Hessen protocols includes a set of status bits that the instrument includes in
responses to inform the host computer of its condition. Each bit can be assigned to one operational and warning
message flag. The default settings for these bit/flags are listed on Table 7-15:
04515F DCN6048