Filter
Top Products
Teledyne API M100E Analyzer Operation Manual Remote Operation and Advanced Features
127
NOTE
It is a good idea to check these settings the first time you power up your analyzer after it has been
physically connected to the LAN/Internet to ensure that the DHCP has successfully downloaded the
appropriate information from you network server(s).
If the gateway IP, instrument IP and the subnet mask are all zeroes (e.g. “0.0.0.0”), the DCHP was not
successful.
You may have to manually configure the analyzer’s Ethernet properties.
See your network administrator.
To view the properties from Table 7-2, access the COMM Menu (refer to Figure 7-1), then press:
SETUP X.X COMMUNICATIONS MENU
ID INET COM1 EXIT
SETUP X.X DHCP: ON
SET> EDIT EXIT
SETUP X.X INST IP: 0.0.0.0
<SET SET> EXIT
SETUP X.X GATEWAY IP: 0.0.0.0
<SET SET> EXIT
SETUP X.X
TCP PORT2: 502
<SET SET> EDIT EXIT
EDIT Key
Disabled
From this point on,
EXIT returns to
COMMUNICATIONS
MENU
Do not alter unless
directed to by Teledyne
Instruments Customer
Service personnel
SETUP X.X
HOSTNAME: M100E
<SET EDIT EXIT
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SETUP X.X SUBNET MASK: 0.0.0.0
<SET SET> EXIT
SETUP X.X
T
CP PORT: 3000
<SET SET> EDIT EXIT
Figure 7-8: COMM – LAN / Internet Configuration Properties
04515F DCN6048