Filter
Top Products
Remote Operation and Advanced Features Teledyne API M100E Analyzer Operation Manual
126
Table 7-2: LAN/Internet Configuration Properties
PROPERTY DEFAULT STATE DESCRIPTION
DHCP STATUS
On Editable
This displays whether the DHCP is
turned ON or OFF.
INSTRUMENT
IP ADDRESS
Configured by
DHCP
EDIT key
disabled when
DHCP is ON
This string of four packets of 1 to 3
numbers each (e.g. 192.168.76.55.) is
the address of the analyzer itself.
GATEWAY IP
ADDRESS
Configured by
DHCP
EDIT key
disabled when
DHCP is ON
A string of numbers very similar to the
Instrument IP address (e.g.
192.168.76.1.)that is the address of the
computer used by your LAN to access
the Internet.
SUBNET MASK
Configured by
DHCP
EDIT key
disabled when
DHCP is ON
Also a string of four packets of 1 to 3
numbers each (e.g. 255.255.252.0)
that defines that identifies the LAN the
device is connected to.
All addressable devices and computers
on a LAN must have the same subnet
mask. Any transmissions sent devices
with different assumed to be outside of
the LAN and are routed through
gateway computer onto the Internet.
TCP PORT
1
3000
Editable
This number defines the terminal
control port by which the instrument is
addressed by terminal emulation
software, such as Internet or Teledyne
API’s APICOM.
HOST NAME M100E
Editable
The name by which your analyzer will
appear when addressed from other
computers on the LAN or via the
Internet. While the default setting for
all Teledyne API M100E analyzers is
“M100E ” the host name may be
changed to fit customer needs.
1
Do not change the setting for this property unless instructed to by Teledyne API’s Customer
Service personnel.
04515F DCN6048