Filter
Top Products
Teledyne API M100E Analyzer Operation Manual Getting Started
47
3.6.3. O
2
SENSOR CALIBRATION PROCEDURE
If your M100E is equipped with the optional O
2
sensor, this sensor should be calibrated during installation of the
instrument. Refer to Section 8.10.1 for instructions
3.6.4. CO
2
SENSOR CALIBRATION PROCEDURE
If your M100E is equipped with the optional CO
2
sensor, this sensor should be calibrated during installation of
the instrument. Refer to Section 8.10.2 for instructions.
The M10
0
E Analyzer is now ready for operation.
NOTE
Once you have completed the above set-up procedures, please fill out the Quality Questionnaire that
was shipped with your unit and return it to Teledyne API.
This information is vital to our efforts in continuously improving our service and our products.
THANK YOU.
04515F DCN6048