Filter
Top Products
Remote Operation and Advanced Features Teledyne API M100E Analyzer Operation Manual
138
7.1.11. COMM PORT TESTING
The serial ports can be tested for correct connection and output in the COMM menu. This test sends a string of
256 ‘w’ characters to the selected COM port. While the test is running, the red LED on the rear panel of the
analyzer should flicker.
To initiate the test press, access the COMM Menu (refer to Figure 7-1), then press:
Select which
COMM port to
test.
SETUP X.X COMMUNICATIONS MENU
ID COM1 COM2 EXIT
SETUP X.X COM1 : TEST PORT
<SET TEST EXIT
SETUP X.X TRANSMITTING TO COM1
<SET TEST EXIT
SETUP X.X COM1 MODE:0
SET> EDIT EXIT
SETUP X.X COM1 BAUD RATE:19200
<SET SET> EDIT EXIT
EXIT returns to
COMM menu
Test runs
automatically
Figure 7-16: COMM – COMM Port Baud Rate
04515F DCN6048