Teledyne GFC7000E Microscope & Magnifier User Manual


 
Model GFC7000E Instruction Manual APPENDIX A-3: Warnings and Test Functions, Revision
E.0APPENDIX A-3: Warnings and Test Functions, Revision E.0
045840110 Rev B.3 238
APPENDIX A-3: Warnings and Test Functions, Revision E.0
Table A-2: GFC7000E Warning Messages, Revision E.0
NAME MESSAGE TEXT DESCRIPTION
WSYSRES SYSTEM RESET Instrument was power-cycled or the CPU was reset.
WDATAINIT DATA INITIALIZED Data storage was erased.
WCONFIGINIT CONFIG INITIALIZED Configuration storage was reset to factory configuration
or erased.
WSOURCE SOURCE WARNING Reference reading below 1250 mV (50 mV in N
2
O, CO
2
,
and high level instruments) or above 4950 mV in normal
sample mode.
WAUTOZERO
4, 5
AZERO WARN 1.001 Auto-reference ratio below limit specified by ZERO_LIMIT
variable.
WBENCHTEMP BENCH TEMP
WARNING
Bench temperature outside of warning limits specified by
BENCH_SET variable.
WWHEELTEMP WHEEL TEMP
WARNING
Wheel temperature outside of warning limits specified by
WHEEL_SET variable.
WSAMPFLOW
6
SAMPLE FLOW WARN Sample flow outside of warning limits specified by
SAMP_FLOW_SET variable.
WSAMPPRESS SAMPLE PRESS WARN Sample pressure outside of warning limits specified by
SAMP_PRESS_SET variable.
WSAMPTEMP SAMPLE TEMP WARN Sample temperature outside of warning limits specified
by SAMP_TEMP_SET variable.
WPURGEPRESS
9
PURGE PRESS WARN Purge pressure outside of warning limits specified by
PURGE_PRESS_SET variable.
WBOXTEMP BOX TEMP WARNING Chassis temperature outside of warning limits specified
by BOX_SET variable.
WSYNC SYNC WARNING SYNC_OK digital input is off.
WPHOTOTEMP PHOTO TEMP
WARNING
Photometer temperature outside of warning limits
specified by PHOTO_TEMP_SET variable.
WDYNZERO CANNOT DYN ZERO Contact closure zero calibration failed while DYN_ZERO
was set to ON.
WDYNSPAN CANNOT DYN SPAN Contact closure span calibration failed while DYN_SPAN
was set to ON.
WREARBOARD REAR BOARD NOT DET Rear board was not detected during power up.
WRELAYBOARD RELAY BOARD WARN Firmware is unable to communicate with the relay board.
WFRONTPANEL FRONT PANEL WARN Firmware is unable to communicate with the front panel.
WANALOGCAL ANALOG CAL WARNING
The A/D or at least one D/A channel has not been
calibrated.