Filter
Top Products
Model GFC7000E Instruction Manual Operating Instructions
04584 Rev A1 125
SAMPLE
ENTER SETUP PASS : 818
8 1 8
ENTR
EXIT
SETUP X.X
PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE* RANGE = 500.000 PPM CO2 =X.XXX
< TST TST > CAL SETUP
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
SETUP X.X COMMUNICATIONS MENU
ID COM1 COM2 EXIT
SETUP X.X COM1 MODE:0
SET>
EDIT
EXIT
Continue pressing next until …
Select which COMM
port to configure
SETUP X.X
COM1 QUIET MODE: OFF
NEXT
OFF ENTR EXIT
SETUP X.X
COM1 HESSEN PROTOCOL : ON
PREV NEXT ON ENTR EXIT
SETUP X.X
COM1 HESSEN PROTOCOL : OFF
PREV NEXT
OFF
ENTR EXIT
ENTR
key accepts the
new settings
EXIT key ignores the
new settin
g
s
The sum of the mode
IDs of the selected
modes is displayed
here
SETUP X.X
COM1 E,7,1 MODE: ON
PREV NEXT
ON
ENTR EXIT
SETUP X.X COM1 E,7,1 MODE: OFF
PREV NEXT
OFF
ENTR EXIT
Toggle OFF/ON
keys
to change
activate/deactivate
selected mode.
Repeat the
entire process to
set up the
COM2 port
6.13.4.4. Selecting a Hessen Protocol Type
Currently there are two versions of Hessen Protocol in use. The original implementation, referred
to as TYPE 1, and a more recently released version, TYPE 2 that has more flexibility when
operating with instruments that can measure more than one type of gas. For more specific
information about the difference between TYPE 1and TYPE 2 download the Manual Addendum for
Hessen Protocol from the Teledyne Instruments web site: http://www.teledyne-
ai.com/manuals/index.asp .
To select a Hessen Protocol Type press:
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE* RANGE = 500.000 PPM CO2 =X.XXX
< TST TST > CAL SETUP
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2
EXIT
SETUP X. HESSEN VARIATION: TYPE 1
SET> EDIT EXIT
SETUP X.X HESSEN VARIATION: TYPE 1
TYE1 TYPE 2 ENTR EXIT
SETUP X.X HESSEN VARIATION: TYPE 2
PREV NEXT OFF ENTR EXIT
Press to change
protocol type.
ENTR key accepts the
new settings
EXIT key ignores the
new settin
g
s