5 - 25
5. PARAMETERS
5.4 I/O setting parameters (No.PD
)
POINT
Parameter whose symbol is preceded by * is made valid with the following
conditions.
* : Set the parameter value, switch power off once after setting, and then
switch it on again, or perform the controller reset.
5.4.1 Parameter list
No. Symbol Name Initial value Unit
PD01 For manufacturer setting 0000h
PD02 0000h
PD03 0000h
PD04 0000h
PD05 0000h
PD06
0000h
PD07 *DO1 Output signal device selection 1 (CN3-13) 0005h
PD08 *DO2 Output signal device selection 2 (CN3-9) 0004h
PD09 *DO3 Output signal device selection 3 (CN3-15) 0003h
PD10 For manufacturer setting 0000h
PD11 0004h
PD12 0000h
PD13
0000h
PD14 *DOP3 Function selection D-3 0000h
PD15 For manufacturer setting 0000h
PD16 0000h
PD17 0000h
PD18 0000h
PD19 0000h
PD20 0000h
PD21 0000h
PD22 0000h
PD23 0000h
PD24 0000h
PD25 0000h
PD26 0000h
PD27 0000h
PD28 0000h
PD29 0000h
PD30 0000h
PD31 0000h
PD32
0000h