Filter
Top Products
Configuration and Use Manual 47
Startup ConfigurationCalibrationBefore You Begin
Chapter 4
Configuration
4.1 Overview
This section describes how to change the operating settings of the transmitter.
Note: All procedures provided in this chapter assume that you have established communication with
the transmitter and that you are complying with all applicable safety requirements. See Appendix C or
the documentation for your PROFIBUS host or configuration tool.
4.2 Default target mode
The default target mode for all blocks is Auto. It is not necessary to set blocks to OOS mode before
changing the parameters described in this chapter.
4.3 Configuration map
Use the map in Table 4-1 to guide you through a complete or partial configuration of the transmitter.
Table 4-1 Configuration map
Topic
Method
SectionEDD ProLink II Display
Gas standard volume ✔✔ 4.4
Measurement units ✔✔✔4.5
Petroleum measurement application ✔✔ 4.6
Concentration measurement application ✔✔ 4.7
Output scale ✔ 4.8
Process alarms ✔ 4.9
Alarm severity ✔✔ 4.10
Damping ✔✔ 4.11
Slug flow ✔✔ 4.12
Cutoffs ✔✔ 4.13
Measurement mode ✔✔ 4.14
Sensor parameters ✔✔ 4.15
Display functionality ✔✔✔4.16