Filter
Top Products
Configuration and Use Manual 25
Calibration
Startup ConfigurationCalibrationBefore You Begin
Figure 3-3 Characterizing the flowmeter
EDD
Bus parameters
ProLink II
Calibration >
Density
Enter values from
sensor tag
MMI Coriolis Flow >
Transducer Block
Sensor Type Code
• Curved Tube
• Straight Tube
Device Information
ProLink >
Configuration
Device tab
Sensor Type
Flow tab
Enter values from
sensor tag
Density tab
Enter values from
sensor tag
(1) Refer to Table 3-1 for bus
parameter indices.
Block: Transducer Block 2 (Slot 12)
Index 12 (sensor type code)
Sensor type
Block: Transducer Block 1 (Slot 11)
See note (1)
Flow values
Block: Transducer Block 1 (Slot 11)
See note (1)
Density values