Filter
Top Products
31 Using the Batteries Checking Battery Charge
300
Battery Status Window
♦ To access the Battery
Status window and its
associated pop-up keys,
select the battery status
information on the
Screen, or select Main
Setup -> Battery.
Capacity, Remaining tells you how much power is left in each battery.
Capacity, Full Charge tells you how much power each battery can hold when fully charged.
Time To Empty tells you approximately how long you can continue to use the monitor with these
batteries. Note that this time fluctuates depending on the system load (the display brightness and how
many measurements and recordings you carry out), the age of the battery, and the remaining capacity
of the battery.
Time To Full is shown in place of Time To Empty if the monitor is connected to mains
power, and tells you how much time is left until the batteries are charged to 90%. When the batteries
are charging you can see how much monitoring time the current charging status represents under the
battery symbol.
Viewing Individual Battery Status
♦ To view information for individual batteries, select the pop-up key Battery 1 or Battery 2.
Recording Battery Status
To print the information in the Battery Status window on a connected recorder,
1 Select the battery status information on the Screen to open the Battery Status window
2 Select the Record Status pop-up key.
Printing Battery Reports
To print the information in the Battery Status window on a connected printer,
1 Select the battery status information on the Screen to open the Battery Status window
2 Select the Print Status pop-up key.
Checking Battery Charge
♦ To check the charge status of a battery in a monitor, see the battery power gauge on the Screen or
select Main Setup -> Battery to enter the Battery Status window.
♦ To check the charge status of a battery that is not connected to a monitor or battery charger, press
the black dot marked “PUSH” on the labeled side of the battery. The remaining charge is indicated
by four LEDs on the electronic fuel gauge directly above the dot. Each LED represents 25% of
Battery Status
TimeToEmpty: 5hrs 10 min
Capacity
remaining
fullCharge
Batt 1
Batt 2
[mAh]
[mAh]
hrs