Filter
Top Products
Changing Loops Display Size 29 Respiratory Loops
291
Changing Loops Display Size
To change the loops display size, in the Loops window, select the pop-up key Select Size then
select
• Size x 0.5 to display loops at half the usual size
• Size x 1 to display loops at the usual size
• Size x 2 to display loops at twice the usual size
This does not affect the size of loops printed in reports.
Using the Loops Cursor
To view the coordinates for any point on a stored loop,
1 Select the pop-up key Select Loop.
2 Select the required loop from the list of available loops.
3 Use the arrow pop-up keys to move the cursor around the loop. The values for both loop axes are
shown for every point on the loop.
Select the X at the top of the loop list to exit the cursor.
Changing Loops Type
To change the loop type, in the Loops window, select the Loop Type pop-up key (only available if
the source device delivers three waves), then select
• Press/Volume to display Pressure/Volume loops
• Flow/Volume to display Volume/Flow loops
• Press/Flow to display Pressure/Flow loops.
or, if the source device only delivers two waves,
1 In the Loops window, select the Setup Device pop-up key to enter the
Setup <VueLink Device> menu.
2 Select Wave 1 and select pressure, flow, or volume waves as required. Repeat for Wave 2.
Setting Up Source Device
The source device for the loops is indicated in the Loops window title.
♦ Select the Setup Device pop-up key to view the settings of the current source device.
If the source device is changed, all reference loops from a previous device are cleared from the reference
list when the first loop from the new source device is captured. Reconnecting the previous device recalls
its reference list.