Filter
Top Products
SECTION 7—BACK ADJUSTMENTS
Part No 1114842 97 2G Tarsys®Powered Seating System
Round Canes
Removing Lateral Supports
NOTE: For this procedure, refer to FIGURE 7.14.
1. Remove the three hex screws securing the half clamps to the back canes.
2. Remove the two socket screws securing the bracket (with lateral support attached) to
the half clamp.
Installing Lateral Supports
NOTE: For this procedure, refer to FIGURE 7.14.
1. Position the half clamps on the back cane.
NOTE: Ensure the half clamp with the threaded holes is towards the front of the wheelchair.
2. Secure the half clamps to the back canes using the three hex screws.
3. Secure the bracket (with lateral support attached) to the half clamp with threaded
holes using two socket screws.
FIGURE 7.14 Removing/Installing Lateral Supports - Round Canes
Adjusting Lateral Height
NOTE: For this procedure, refer to
FIGURE 7.15.
1. Loosen, but DO NOT remove, the three
socket screws securing the half clamps
to the back cane.
2. Adjust the height of the lateral support.
3. Tighten the three socket screws to
secure the half clamps to the back cane.
FIGURE 7.15 Adjusting Lateral Height
Lateral
Support
Socket
Screws
Half Clamp with
Threaded Holes
Half Clamp
Back Cane
Socket
Screws
Bracket
Front of
Wheelchair
Rear of
Wheelchair
Lateral
Support
Socket Screws
Half Clamp
Back Cane