Filter
Top Products
SECTION 5—INTERFACE HARDWARE
2G Tarsys®Powered Seating System 44 Part No 1114842
Recline Only Systems
NOTE: For this procedure, refer to FIGURE 5.3.
Removing
1. Remove the seat assembly. Refer to Removing/Installing the Seat on page 75.
2. Note the mounting location of the six hex screws, washers and locknuts securing the
rear pivot assembly to the spacer bars, seat brackets and lower interface brackets.
3. Remove the six hex screws, washers and locknuts securing the rear pivot assembly to
the spacer bars, seat brackets and lower interface brackets.
4. Remove the rear pivot assembly from the wheelchair.
Installing
1. Align the rear pivot assembly, spacer bars, seat brackets and lower interface brackets.
2. Using the six hex screws, washers and locknuts, secure the rear pivot assembly to the
spacer bars, seat brackets and lower interface brackets in the locations noted in STEP
2 of Removing on page 44. Torque to 75 in-lbs ± 20%.
3. Install the seat assembly. Refer to Removing/Installing the Seat on page 75.
FIGURE 5.3 Removing/Installing the Rear Pivot Assembly
NOTE: Only one seat
adjustment position shown.
All seat adjustment positions
remove/install in the same
way.
Locknuts
Lower Interface Bracket
Washer
Seat
Bracket
Spacer Bar
Rear Pivot Assembly
Hex Screw