Filter
Top Products
SECTION 9—POWER ELEVATING LEGRESTS
Part No 1114842 111 2G Tarsys®Powered Seating System
2. Secure the power elevating legrest connector to the harness wire bracket using the two
cap screws and locknuts.
3. Tie-wrap the harness to the lower seat shroud (Detail “A”).
4. Secure the harness to the lower seat shroud using hook and loop fastening strips.
5. Plug the harness into the TRCM 2-pin Anderson connector.
6. Repeat STEPS 2-5 for the opposite side of the wheelchair.
7. Install the power elevating legrests. Refer to Installing/Removing the Power Elevating
Legrests on page 104.
FIGURE 9.9 Removing/Installing the Power Elevating Legrest Harness
DETAIL “A” - TIE-WRAPS AND FASTENING STRIPS
Power Legrest
Connectors
Anderson 2-Pin
Connector (To TRCM)
Tie-Wraps
Tie-Wraps
Lower Seat Shroud
Hook and Loop
Fastening Strips
Hook and Loop
Fastening Strip
Hook and Loop
Fastening Strip
To Left Power Elevating
Legrest
To Right Power
Elevating Legrest
To TRCM
To TRCM
Cap Screws
Locknuts
Harness
Connector
Harness Wire Bracket
Socket Screw
Half Clamp
Seat Frame