Filter
Top Products
SECTION 5—INTERFACE HARDWARE
2G Tarsys®Powered Seating System 48 Part No 1114842
FIGURE 5.5 Removing/Installing the Linear Guides
Removing/Installing the Seat Brackets
Tilt Only and Tilt/Recline Systems
NOTE: For this procedure, refer to FIGURE 5.6 on page 50.
Removing
1. Remove the seat assembly from the rear pivot assembly. Refer to Removing/Installing
the Seat on page 75.
2. Note the mounting location of the four hex screws and locknuts securing the front
pivot assembly to the seat brackets.
Locknut
NOTE: Front of tilt actuator
shown disassembled for clarity
only. There is no need to remove
the hardware securing the front of
the tilt actuator for this procedure.
Bushings
Tilt Actuator
Shoulder Bolt
Clamp Bar
Rear Pivot Assembly
Upper Portion of
Linear Guide
Lower Portion of
Linear Guide
Socket Screw
Seat Bracket
Lower Interface Bracket
Shim
Washer
Locknut
Access Hole