Filter
Top Products
SECTION 6—SEAT ADJUSTMENTS
2G Tarsys®Powered Seating System 68 Part No 1114842
6. Secure the slide rod to the side frame, with the slide block in position, with the two
hex screws and washers. Torque to 13 ft-lbs ± 20% (156 in-lbs ± 20%).
FIGURE 6.11 Preparing Side Frames for Replacement - Tilt-Only Seating Systems
Tilt/Recline and Recline-Only Seating Systems
NOTE: For this procedure, refer to FIGURE 6.12 on page 69.
1. Remove the hex screw and washer that secure the slide block to the slide block
connecting bracket.
2. Remove the two hex screws and washers that secure the slide rod to the side frame.
3. Remove the slide rod and slide block from the side frame.
4. Secure the slide rod to the side frame, with the slide block in position, with the two
hex screws and washers. Torque to 13 ft-lbs ± 20% (156 in-lbs ± 20%).
5. Secure the slide block to the slide block connecting bracket with the hex screw and
washer. Torque to 156 in-lbs ± 20%.
Side Frame
Locknut
Connecting
Bracket
Hex Screw
Washer
Slide Rod
Hex Screw
Washer
Washer
Hex Screw
DETAIL “A” - INSIDE
VIEW OF CONNECTING
BRACKET ON SIDE
FRAME
NOTE: In Detail “A”, the mounting position of
the hex screw on the connecting bracket shows a
back angle of 115°. For additional back angles
refer to Adjusting Back Angle on page 80.
Mounting Position
Slide Block