Filter
Top Products
SECTION 9—POWER ELEVATING LEGRESTS
2G Tarsys®Powered Seating System 106 Part No 1114842
Adjusting the Power Elevating Legrests
Adjusting the Footplate
ƽ WARNING
DO NOT remove heel loops without providing some other adequate means of
support, otherwise personal injury may occur.
Adjusting the Footplate Height
NOTE: For this procedure, refer to FIGURE 9.2.
NOTE: The following procedure should be performed with the user in the wheelchair.
NOTE: T-nuts ride in the channels of the exterior/interior rails of the power legrests.
1. Loosen, but DO NOT remove, the two interior button screws that secure the footplate
assembly to the T-nuts.
2. Loosen, but DO NOT remove, the two exterior button screws that secure the footplate
assembly to the T-nuts.
3. Loosen, but DO NOT remove, the two button screws that secure the heel loop to the
T-nuts.
4. Slide footplate assembly up or down, until desired height is achieved.
5. While holding footplate assembly in position, tighten all six button screws that were
loosened in STEPS 1-3.
6. Repeat STEPS 1–5 for opposite footplate if necessary.
FIGURE 9.2 Adjusting the Footplate Height
Exterior Rail
Channel
T-Nuts (Not Shown)
Footplate
Assembly
Exterior
Button Screws
Outside View
Inside View
Channel
T-Nuts (Not Shown)
Footplate Assembly
Interior Button
Screws
Button Screws
for Heel Loop