Filter
Top Products
SECTION 13—TILT AND RECLINE
2G Tarsys®Powered Seating System 126 Part No 1114842
SECTION 13—TILT AND RECLINE
ƽ WARNING
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Before adjusting, repairing or servicing the seating system, ALWAYS turn the
wheelchair power OFF, otherwise, injury or damage may result.
Pinch points exist between seat and base frames. Use caution, otherwise injury may
occur.
A Note About Drive Lock-Out
ƽ WARNING
NEVER operate the wheelchair while in any tilted/reclined/back angle position over
20° relative to the vertical position. If the drive lock-out does not stop the
wheelchair from operating in a tilt position over 20° relative to the vertical position,
DO NOT operate the wheelchair. DO NOT attempt to adjust the drive lock-out.
Have the wheelchair serviced by a qualified technician.
The wheelchair user MUST have a clear line of sight to drive safely. On initial chair
delivery and after adjusting the back angle, drive lock-out switch, tilt system or
recline system, tilt and recline the seat back to the farthest driving position
immediately before drive lock-out engages and ensure there is a clear line of sight
present in which to drive the wheelchair. If a clear line of sight is not present, have
the back angle repositioned or readjust the lockout angle such that safe driving with
a clear line of sight is achieved. Otherwise injury or damage may occur.
The LED on the single function toggle switch will light when the drive lock-out feature
has been activated. Drive lock-out is a feature designed to prevent the wheelchair from
being driven after the seating system has been tilted or reclined beyond 20°* relative to
the vertical position. The back can be positioned at a 10° relative offset to the seat base,
thereby resulting in a back angle potential of 30° before which the drive lock-out is
activated. This may affect the wheelchair user’s line of sight while driving. Make sure the
wheelchair user can see properly to ensure safe driving.
*NOTE: 20° back angle can be any combination of recline, tilt and/or surface angle.
NOTE: Refer to Typical Product Parameters on page 12 for tilt and/or recline angle ranges.