Filter
Top Products
SECTION 6—SEAT ADJUSTMENTS
2G Tarsys®Powered Seating System 56 Part No 1114842
Tilt-Only Seating Systems
NOTE: For this procedure, refer to FIGURE 6.3.
1. Remove the four hex bolts, coved washers, spacers and locknuts that secure the side
frames to the center seat frame.
ƽ WARNING
Both side frames MUST be adjusted to the same mounting hole position to
maintain an even weight distribution of user and seat frame over the base frame. If
weight is not distributed evenly, injury to the assistant and/or user and damage to
the wheelchair may occur.
2. Slide the side frames in and/or out to the desired seat width. Make sure both side
frames are at the same seat width. Refer to Detail “A” in FIGURE 6.3.
3. Reinstall the four hex bolts, coved washers, spacers and locknuts that secure the side
frames to the center seat frame. Torque to 75 in-lbs ± 20%.
4. Reassemble the wheelchair by reversing the instructions in Preparing to Adjust Seat
Width on page 55.
FIGURE 6.3 Adjusting Seat Width - Tilt-Only Seating Systems
16
17
18
19
20
22
21
Spacer
Coved Washer
Hex
Bolts
Side Frame
Locknut
Center Seat Frame
DETAIL “A”
Seat Width Mounting
Hole Positions
NOTE: One side frame shown
for clarity. Opposite side frame
has the same mounting hole
pattern.