Filter
Top Products
SECTION 8—SHROUDS
2G Tarsys®Powered Seating System 100 Part No 1114842
Removing/Installing VSR Shroud
NOTE: For this procedure, refer to FIGURE 8.2.
1. To remove, cut the two tie-wraps that secure the VSR shroud in place.
2. Pull on the VSR shroud to disengage from the fastening strip.
3. Secure VSR shroud to VSR mounting tube in place with two tie-wraps as shown in
FIGURE 8.2.
FIGURE 8.2 Removing/Installing VSR Shroud
Removing/Installing Side Shrouds
ƽ WARNING
Side shroud(s) MUST be reinstalled before operation of the seating system.
Otherwise injury may result.
NOTE: For this procedure, refer to FIGURE 8.3 on page 101.
1. Remove the mounting screw and washer that secure the side shroud to the seat frame.
2. To install side shrouds, align side shroud with fastening strips and secure with
mounting screw and washer. Securely tighten.
NOTE: Only the right side shroud is shown for clarity. The left side shroud removes/installs in the
same manner.
VSR Mounting
Tube
Tie-Wraps
VSR
Shroud
Fastening
Strip