Filter
Top Products
SECTION 14—ELECTRONICS
2G Tarsys®Powered Seating System 148 Part No 1114842
ƽ WARNING
NEVER operate the wheelchair while the seat is in any seat angle position over 20°
RELATIVE TO THE VERTICAL POSITION. Drive lockout MUST not be adjusted
beyond 20°.
The wheelchair user MUST have a clear line of sight to drive safely. On initial chair
delivery and after adjusting the back angle, drive lockout switch or tilt system, tilt
the seat back to the farthest driving position immediately before drive lockout
engages and ensure there is a clear line of sight present in which to drive the wheel-
chair. If a clear line of sight is not present, have the back angle repositioned or read-
just the lockout angle such that safe driving with a clear line of sight is achieved.
Otherwise injury or damage may occur.
19. Tilt the system up and down and test that the drive lockout works at no more than 20°
of tilt.
20. Secure the TAC cables. Refer to TAC Cables on page 157.
Replacing the Tilt Recline Single Switch (TRSS)
NOTE: For this procedure, refer to FIGURE 14.4 on page 149.
1. Turn the joystick off.
2. Disconnect the joystick.
3. Disconnect the auxiliary power connectors.
4. Disconnect the actuator (WHITE connector).
5. Disconnect the mercury switch (3-pin Molex connector).
6. Note the locations of any tie-wraps securing cables connected to the TRSS for proper
installation.
7. Cut the tie-wraps securing the cables connected to the TRSS.
8. Remove the two button head screws securing the TRSS to the mounting bracket.
9. Remove the TRSS from the mounting bracket.
10. Reverse STEPS 2–9 to install the TRSS.
11. Perform the post-service inspection. Refer to Post-Service Inspection Checklist on
page 21.