Filter
Top Products
SECTION 6—SEAT ADJUSTMENTS
2G Tarsys®Powered Seating System 66 Part No 1114842
FIGURE 6.9 Replacing Recline Links
Removing/Installing Side Frames
Removing Side Frames
NOTE: For this procedure, refer to FIGURE 6.10 on page 67.
1. Recline backward 5 to 10 degrees and/or tilt backward 5 to 10 degrees in order to
enable hardware removal.
2. Remove the side shrouds. Refer to Removing/Installing Side Shrouds
on page 100.
3. Remove the seat pan. Refer to Removing/Installing Seat Pan
on page 54.
4. Remove the arms. Refer to Arms
on page 114.
5. Remove the back. Refer to Removing/Installing Back Assembly on page 91.
6. Remove the telescoping front rigging supports. Refer to Adjusting/Replacing
Telescoping Front Rigging Supports on page 73.
Mounting Hole
for 10° Recline
Mounting Hole
for 15° Recline
Washer
*Retaining
Ring
*NOTE: Use new retaining ring.
DETAIL A: 10°/15° RECLINE LINK
Mounting Hole
for 10° Recline
Mounting Hole
for 15° Recline
Shoulder
Bolt
Front Pivot
Assembly
Locknut
10° and 15° Recline Link
Mounting Hole for 5° Recline
Mounting Hole
for 0° Recline
Washer
*Retaining
Ring
*NOTE: Use new retaining ring.
DETAIL B: 0°/5° RECLINE LINK
Mounting Hole for 0° Recline
Mounting Hole
for 5° Recline
Shoulder
Bolt
Front Pivot
Assembly
Locknut
0° and 5° Recline Link
Mounting Reclining Link to Center Seat Frame
Mounting Reclining Link to Center Seat Frame
Mounting Reclining Link
to Front Pivot Assembly
Mounting Reclining Link
to Front Pivot Assembly