Filter
Top Products
SECTION 5—INTERFACE HARDWARE
Part No 1114842 51 2G Tarsys®Powered Seating System
Recline Only Systems
NOTE: For this procedure, refer to FIGURE 5.7 on page 52.
Removing
1. Remove the seat assembly from the rear pivot assembly. Refer to Removing/Installing
the Seat on page 75.
2. Note the mounting location of the four hex screws and locknuts securing the front
pivot assembly to the seat brackets.
3. Remove the four hex screws and locknuts securing the front pivot assembly to the seat
brackets.
4. Remove the front pivot assembly from the seat brackets.
5. Note the mounting location of the six socket screws, washers and locknuts securing
the rear pivot assembly to the spacer bars, seat brackets and lower interface brackets.
6. Remove the six socket screws, washers and locknuts securing the rear pivot assembly
to the spacer bars, seat brackets and lower interface brackets.
7. Remove the rear pivot assembly from the wheelchair.
8. Note the mounting location of the hex screw and locknut securing the inside of the
seat bracket to the lower interface bracket.
9. Remove the hex screw and locknut securing the inside of the seat bracket to the lower
interface bracket.
10. Remove the seat bracket from the lower interface bracket.
11. Repeat STEP 8 to STEP 10 for the opposite side if desired.
Installing
1. Using the hex screw and locknut, secure the inside of the seat bracket to the lower
interface bracket in the location noted in STEP 8 of Removing
. Torque to 13 ft-lbs ±
20%.
2. Repeat STEP 1 for the opposite side if necessary.
3. Align the front pivot assembly with the seat brackets.
4. Secure the front pivot assembly to the seat brackets in the location noted in STEP 2 of
Removing above. Torque to 13 ft-lbs ± 20%.
5. Using the six hex screws, washers and locknuts, secure the rear pivot assembly to the
spacer bars, seat brackets and lower interface brackets in the location noted in STEP 5
of removing above. Torque to 75 in-lbs ± 20%.
6. Install the seat assembly. Refer to Removing/Installing the Seat on page 75.