Filter
Top Products
SECTION 14—ELECTRONICS
Part No 1114842 141 2G Tarsys®Powered Seating System
FIGURE 14.1 Removing/Installing the Single Actuator Control (SAC)
Removing/Installing the TAC or TRCM
NOTE: For this procedure, refer to FIGURE 14.2 on page 143 and FIGURE 14.3 on page 145.
NOTE: TAC stands for Two Actuator Control.
NOTE: TRCM stands for Tilt Recline Control Module.
Removing the TAC/TRCM Controller Bracket
Round Back Canes
1. Remove the two long hex screws and locknuts securing the controller bracket to the
upper bracket (Detail “C”).
Half Clamp
(Threaded)
Armrest
Half Clamp (Non-threaded)
Mounting Screws
Mounting Plate
SAC
Hex Screws
SAC
5-pin Connector
(To Controller)
Auxiliary Power Connector
Actuator Connector
(WHITE 2-pin Anderson)
SAC Connector
(3-Pin Molex)
DETAIL “A”
DETAIL “B”