Filter
Top Products
SECTION 14—ELECTRONICS
Part No 1114842 147 2G Tarsys®Powered Seating System
6. Press the SELECT key on the programmer to proceed to the Tilt Down adjustment
screen.
7. Tilt the seat until the measured angle is approximately 50°.
8. Adjust the tilt down angle setting on the programmer to the measured angle. The
range is between 45°and 55°.
9. Press the SAVE key on the programmer to store both the up and down angle
adjustments in the user memory.
NOTE: The adjustments in STEPS 10 to 15 will ensure the programmed angle setting for the seat
matches the mechanical adjustment made for the seat. This will prevent the actuator from running
excessively when the seat has finished moving.
10. Press the Menu button.
11. Select PERFORMANCE ADJUST and press the Select button.
NOTE: For STEP 12, listen to the tilt actuator while observing the seat position.
12. Tilt the seating system to the full upright position.
13. Perform one of the following:
• If the tilt actuator continues to run after the seating system stops moving, proceed
to STEP 14.
• If the tilt actuator stops when the seating system stops moving, proceed to STEP 17.
14. Increase the tilt up angle setting on the programmer.
15. Press the Save button.
16. Repeat STEPS 10 to 15 until the actuator stops when the seating system stops moving.
17. Press the Power button.
18. Disconnect the remote programmer from the TAC.
TILT UP ANGLE
5
PRESS SELECT
TO CONTINUE
TILT DOWN ANGLE
50
PRESS SAVE
TO SET ANGLES