Filter
Top Products
SECTION 12—HEADREST
Part No 1114842 125 2G Tarsys®Powered Seating System
Adjusting Headrest Height
1. Loosen the set screw on the headrest stop.
2. Loosen, but DO NOT remove, the thumb screw that secures the headrest to the
headrest mounting bracket.
3. Position the headrest to the desired height.
4. Tighten the thumb screw that secures the headrest to the headrest mounting bracket.
5. Tighten the set screw on the headrest stop.
6. If necessary, adjust the depth or direction of the headrest. Refer to Adjusting Headrest
Depth/Direction below.
Adjusting Headrest Depth/Direction
1. Loosen, but DO NOT remove, the three socket screws that secure the offset fixture to
the slide tube.
2. If necessary, reposition the headrest to the desired depth by sliding the headrest
towards the front of the wheelchair or towards the rear of the wheelchair.
3. If necessary, reposition the headrest to the desired position (headrest will move in any
direction).
4. While holding the headrest in the desired position, securely tighten the three socket
screws.
5. If necessary, adjust the height of the headrest. Refer to Adjusting Headrest Height
above.
Replacing Headrest
NOTE: For this procedure, refer to FIGURE 12.2.
1. Remove the three socket screws that
secure the headrest to the headrest
mounting bracket.
2. Position the new headrest on the
headrest mounting bracket and secure
with the existing three socket screws.
3. If necessary, adjust the height, depth or
direction of the headrest. Refer to
Adjusting Headrest Height above.
FIGURE 12.2 Replacing Headrest
Headrest Mounting
Bracket
Socket
Screw
Headrest
NOTE: One style of headrest shown
for clarity. Both styles of headrest
attach the same way.