Filter
Top Products
SECTION 9—POWER ELEVATING LEGRESTS
Part No 1114842 105 2G Tarsys®Powered Seating System
Installing the Power Elevating Legrests
1. Turn power legrest to side (open footplate is perpendicular to wheelchair) and
position the mounting pin on the legrest with mounting holes on the seat frame
(Detail “A”).
2. Insert the mounting pin of power legrest into the mounting hole of the seat frame
(Detail “A”).
NOTE: Make sure the legrest sits flush on the seat frame.
3. Rotate the power leg toward the inside of the wheelchair until it locks in place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat STEPS 1-3 for the opposite legrest.
5. Connect the power legrest connectors (Detail “B”).
6. If necessary, adjust powered legs. Refer to Adjusting the Power Elevating Legrests on
page 106.
Removing the Power Elevating Legrests
1. Disconnect power legrest connectors.
2. Push powered legrest release handle toward the opposite side of the wheelchair and
swing legrest to the outside of the wheelchair.
3. Lift up powered legrest and remove from wheelchair.
4. Repeat STEPS 1-3 for opposite power legrest.
FIGURE 9.1 Installing/Removing the Power Elevating Legrests
Calf Pad
Footplate
Legrest Release
Handle
DETAIL “A”
DETAIL “B”
Power Legrest
Connectors
Mounting
Hole
Mounting Pin