Filter
Top Products
SECTION 6—SEAT ADJUSTMENTS
Part No 1114842 79 2G Tarsys®Powered Seating System
3. Perform one of the following:
• Recline Only Systems -
i. One person should support the front of the seating system.
ii. The other person should secure the recline links to the front pivot assembly,
using the two shoulder bolts and locknuts in the location noted when removing
the seating system (Detail “C”). Torque to 23 ft-lbs ± 20%.
iii. Connect the recline potentiometer connector (3-pin Molex) to the TRCM.
• Tilt Only and Tilt/Recline Systems -
i. One person should support the front of the seating system.
ii. Using the two shoulder bolts and locknuts, the other person should secure the
tilt links, bushings and tilt angle blocks to the front pivot assembly (Detail “B”).
Torque to 23 ft-lbs ± 20%.
NOTE: The tilt angle blocks should be mounted in the position noted when removing the
seating system.
iii. Install the socket screw to secure the tilt potentiometer linkage to the center seat
frame (Detail “A”).
4. Connect the cables.
Connecting Cables
NOTE: For this procedure refer to FIGURE 6.17 on page 76.
1. Perform one of the following:
• Tilt Only and Tilt/Recline Systems -
i. Connect the tilt actuator connector (2-pin Anderson) to the TRCM, TAC, SAC
or TRSS.
ii. Connect the tilt potentiometer connector (3-pin Molex) to the TRCM, TAC, SAC
or TRSS.
• Recline Only Systems - Connect the recline potentiometer connector (3-pin Molex)
to the TRCM, TAC, SAC or TRSS.
2. Connect the auxiliary power connector to the power take-off connector (not shown)
on the controller.
3. Connect the TRCM, SAC or TAC to the MK
5
controller (5-pin connector).
4. Connect the joystick.
5. Perform the post-service inspection of the system. Refer to Post-Service Inspection
Checklist on page 21.