Filter
Top Products
SECTION 15—WIRING AND CABLES
Part No 1114842 157 2G Tarsys®Powered Seating System
SECTION 15—WIRING AND CABLES
ƽ WARNING
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Before adjusting, repairing or servicing the seating system, ALWAYS turn the
wheelchair power OFF, otherwise, injury or damage may result.
Pinch points exist between seat and base frames. Use caution, otherwise injury may
occur.
Securing the Cables
ƽ WARNING
Cables MUST be secured to the wheelchair frame and/or base with tie-wraps after
servicing is complete. Failure to follow the warnings and instructions below could
result in injury to the users, attendants and/or bystanders and/or damage to the
wheelchair.
Cables MUST be secured so there are no loops of excess cable extending away from
the wheelchair. Bundle all excess cable together and secure with a tie-wrap. It may
also be necessary to secure these bundles to the frame and/or base.
Always test all wheelchair functions after securing the cables to be sure cables DO
NOT get pinched or crushed during operation of the wheelchair.
TAC Cables
NOTE: For this procedure, refer to FIGURE 15.1 on page 158.
1. Make sure the wheelchair is in the upright position.
CAUTION
The wheelchair MUST be in the upright position before securing the TAC cables to
prevent stretching and possibly breaking cables.
2. Tie-wrap the auxiliary power connector/potentiometer cable, actuator cable and MK
5
Controller (5-pin connector) cable from the TAC.
NOTE: The accessory cable (9-pin sub D) does not need to be tie-wrapped with the other cables.