Filter
Top Products
SECTION 9—POWER ELEVATING LEGRESTS
2G Tarsys®Powered Seating System 112 Part No 1114842
Removing/Installing the Power Elevating Legrest
Actuator
NOTE: For this procedure, refer to FIGURE 9.10 on page 113.
Removing
1. Remove the power elevating legrest from the wheelchair. Refer to
Installing/Removing the Power Elevating Legrests on page 104.
2. Remove the long shoulder screw, flat washer, washer and locknut securing the top of
the power elevating legrest actuator to the power legrest bracket.
3. Remove the short shoulder screw and locknut securing the actuator rod to the actuator
bracket.
4. Remove the power elevating legrest actuator from the legrest.
Installing
1. Unscrew the actuator rod one half turn.
2. Secure the actuator rod to the actuator bracket using the short shoulder screw and
locknut.
3. Secure the top of the power elevating legrest actuator to the power legrest bracket
using the long shoulder screw, flat washer, washer and locknut.
NOTE: The shoulder screw should be on the inside of the legrest and the locknut should be toward
the outside of the legrest.
4. Install the power elevating legrest. Refer to Installing/Removing the Power Elevating
Legrests on page 104.
5. Perform the post-service inspection. Refer to Post-Service Inspection Checklist on
page 21.