Filter
Top Products
SECTION 7—BACK ADJUSTMENTS
2G Tarsys®Powered Seating System 84 Part No 1114842
Installing
CAUTION
The curved link MUST be installed with the notched side facing out. Otherwise,
damage to the seating system may result.
1. Orient the curved link so the notched side is facing out.
2. Secure the top of the curved link to the back cane using the short socket screw, nylon
washer, flat washer and locknut. Torque to 156 in-lbs ± 20%.
3. Secure the bottom of the curved link to the rear of the slide block and the connecting
bracket using the long socket screw, nylon washer and locknut in the same position
used on the opposite side of the wheelchair. Torque to 23 ft-lbs ± 20%.
ƽ WARNING
Side shroud(s) MUST be reinstalled before operation of the seating system.
Otherwise injury may result.
4. Install the side shroud. Refer to Removing/Installing Side Shrouds on page 100.
FIGURE 7.3 Removing/Installing the Curved Links - Recline Only and Tilt/Recline Systems
Long Socket Screw
Nylon
Washer
Locknuts
Connecting
Bracket
Short
Socket
Screw
Curved Link
Back
Cane
Nylon
Washer
Flat
Washer
Slide Block
Notch