Filter
Top Products
SECTION 6—SEAT ADJUSTMENTS
Part No 1114842 61 2G Tarsys®Powered Seating System
Adjusting Seat Angle
Tilt-Only and Tilt/Recline Seating Systems
NOTE: For this procedure, refer to FIGURE 6.5 on page 61.
1. To gain access to the mounting hardware, tilt seating system back to 45 degrees.
2. Remove the batteries.
3. Remove the shoulder bolt, spacer and locknut that secure the angle block to the front
pivot assembly.
4. Secure the angle blocks and links to the front pivot assembly with the shoulder bolts,
spacers and locknuts in one of the positions shown in FIGURE 6.5. Securely tighten.
5. Adjust the tilt potentiometer. Refer to the electronics manual listed in Reference
Documents on page 2.
6. Perform the post-service inspection. Refer to Post-Service Inspection Checklist
on
page 21.
FIGURE 6.5 Adjusting Seat Angle - Tilt-Only and Tilt/Recline Seating Systems
Recline-Only Seating Systems
Preparing to Adjust the Seat Angle
NOTE: For this procedure, refer to FIGURE 6.6 on page 62.
1. Visually inspect the seating system for either 10°/15° recline links or 0°/5° recline links.
2. Perform one of the following:
Orientation of Angle Block
Shown is for 5° Seat Angle
Locknuts
Spacer
Spacer
Link
Shoulder Bolt
Mounting Hole for 0°
Seat Angle
Use this Mounting
Hole for 0° Seat
Front Pivot Assembly
Orientation of Angle Block
Shown is for 0° Seat Angle
Shoulder Bolt
Link
Mounting Hole
for 5° Recline
Use this Mounting
Hole for 5° Seat
Angle