Filter
Top Products
SECTION 6—SEAT ADJUSTMENTS
2G Tarsys®Powered Seating System 54 Part No 1114842
SECTION 6—SEAT ADJUSTMENTS
ƽ WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Before adjusting, repairing or servicing the seating system, ALWAYS turn the
wheelchair power OFF, otherwise, injury or damage may result.
Pinch points exist between seat and base frames. Use caution, otherwise injury may
occur.
Replacing Seat Positioning Strap
NOTE: For this procedure, refer to
FIGURE 6.1.
1. Remove the two hex bolts, washers and
locknuts that secure the two halves of
the seat positioning strap to the seat
frame.
2. Remove the existing seat positioning
strap from the seat frame.
3. Position the new seat positioning strap
on the seat frame as shown.
4. Reinstall the hex bolt, washer and
locknut as shown. Tighten securely.
FIGURE 6.1 Replacing Seat Positioning
Strap
Removing/Installing Seat Pan
NOTE: For this procedure, refer to FIGURE 6.2 on page 55.
Removing
1. Remove the seat cushion from the seat pan.
2. Remove the five hex bolts, locknuts, coved washer and spacers that secure the seat pan
to the seat frame.
Installing
1. Position the new/existing seat pan on the seat frame, aligning the mounting holes of
the seat pan and the mounting holes of the seat frame.
Seat
Positioning
Strap
Strap
Mounts
Here
Locknut
Spacer
Hex
Bolt
Seat Frame