Filter
Top Products
3 - 44
3.5.7.4 Valious operation for specimen stage
The following operation methods are available.
(a) Operation on the Stage tab of the operation panel (all 5 axes)
(b) Manual operation using trackball (X and Y)
(c) Mouse operation on the image (all 5 axes)
(d) Position memory function (X, Y and R axes)
(e) Stage history function
memorize position where capturing or photographing was performed, or manually
registered and display the trajectory of above points. Re-set stage to memorized position
also possible
(f) Image Navigation function
go to assigned position on captured images or imported external images
(g) Rotation assist function
Assist to observe points these are possible to be observed by rotation
(h) Alignment function (option)
Enables to use sample coordinates
CAUTION
The specimen size and height, and detectors being used must be set correctly to
allow motion of each axis in the proper ranges. If this is not done, the specimen may
strike the objective lens and cause damage to the specimen and objective lens