Filter
Top Products
2 - 44
2.3.7.3 Stage and image shift tools
Controls shown below will be shown on the scanning image.
Type1 manual stage Type2 motorized stage
Fig 2-23 Mouse control (stage)
(1) Type1 manual stage
It is for image shift operation. Move the mouse pointer to a position to be moved and
press down left or right button. The pointer will be changed to
mark. Move mouse to
target position holding down the button and then release the button.
If the above target position is near the center of the image area, the mause trace line is
changed and the target position is fixed to the center of image.
(2) Type2 motorized stage
All 5 axes are controlled with stage control tools. Refer to 3.5.7 for operation procedure.
2.3.8 Setup dialog window
The Setup dialog window has four tabs. To open the dialog window, use the following operation.
(1) Click the Setup
button on the Tool button area of the Operation panel.
(2) Select following commands from the Setup menu.
Setup – Column : Opens Column tab
Setup – Condition Load : Opens Op. Cond tab
Setup – Condition Save : Opens Op. Cond tab
Setup – Image Display : Opens Image tab
Setup – Photo Condition : Opens Record tab
Setup – Data Display : Opens Record tab
(3) Click the Setup button on the OPE CONDITION block of the Operation panel
(4) Click the Load/Save button on the OPE CONDITION block of the Operation panel