Filter
Top Products
4535 612 34161 HD3 Service Manual Page 80
CSIP Level 1 Installation: Powering On and Configuring the System
4. Click System Network Settings.
The System Network Settings window opens (Figure 5-4).
5. View or enter the Network properties for this HD3 in the corresponding fields. If you enter
properties, click Apply when finished, otherwise click Close.
➤ To identify the DICOM storage devices that the system will use
1. Click Add in the DICOM setup window (Figure 5-3).
The Server Configuration window opens (Figure 5-5).
2. Select STORE from the Service menu.
3. Enter all of the parameters for the storage device.
4. Click OK.
5. Repeat step 1 through step 4 for each storage device the system will use.
NOTE You can configure multiple storage devices and printers, but the system will send only
to the storage device and the printer selected.
➤ To identify the DICOM printers that the system will use
1. Click Add in the DICOM setup window (Figure 5-3).
The Server Configuration window opens (Figure 5-5).
2. Select PRINT from the Service menu.
3. Enter all of the parameters for the printer.
4. Click OK.
5. Repeat step 1 through step 4 for each storage device the system will use.