Filter
Top Products
4535 612 34161 HD3 Service Manual Page 72
CSIP Level 1 Installation: Assembling the System
Assembling
the System
Assemble the HD3 system by installing the following components.
Installing the
Printers, VCR,
and Footswitch
If the system is ordered with a B/W printer, it will come installed from the factory in the B/W
printer bay (Figure 1-1) .
If the system comes with a color printer or VCR, you will need to install it on the adjustable uni-
versal peripheral mounting plate, which is installed on the cart from the factory. Follow the color
printer or VCR installation instructions (“To install the color printer” on page 105, or “To install
the VCR” on page 111).
If the system comes with a footswitch, you will need to connect it. Follow the footswitch instal-
lation instructions (“To install the foot switch” on page 119).
NOTE The peripherals come from the factory already configured with the Philips-recom-
mended settings (refer to “Peripheral Settings” on page 266).
Installing the
System Power
Cord
After the system has been inspected and properly assembled, if the system power cord is not
already installed, install the system power cord by following the instructions in “To install the sys-
tem power cord” on page 121.
Powering On
and Config-
uring the
System
When physical installation is complete, it is necessary and important to verify that the system is
properly configured.
After the system has been inspected and properly assembled as instructed in this section, verify
that the green AC Mains power switch (Figure 11-6) is in the off position (“O” label on rocker
switch is pushed in) and then plug the system power cord into a proper AC outlet. Push the AC
Mains power switch to the on position (“I” label on rocker switch is pushed in) and then press,