Filter
Top Products
4535 612 34161 HD3 Service Manual Page 264
CSIP Level 1 Configuration: Disk Drive Settings
Disk Drive
Settings
The jumper positions and switch settings of the drives in the HD3 system depend on the manu-
facturer of the drives.
Hard Drive
Jumpers
Figure 13-17 shows typical hard drive jumper positions. Examine the drive itself for information
on the correct settings. The hard drive is the only device on the primary IDE, and is usually set
to MASTER or SINGLE.
Figure 13-17 Hard Drive Jumper Settings
Pin 1
Master jumper
configuration
IG
H
A
B
Power connectorSignal connector
Hard drive
Jumper
MASTER = ON
SLAVE = OFF