Filter
Top Products
4535 612 34161 HD3 Service Manual Page 137
CSIP Level 1 Adjustments: Introduction
7 Adjustments
Introduction
This section contains information for adjusting the system monitor. Except for the monitor,
there are no other calibration or alignment adjustments to make in the field for this system.
There are no voltage adjustments to make in the field for this system.
Adjusting the
Monitor
You can adjust the brightness of the monitor image to compensate for ambient light.
The only monitor adjustment is the video brightness, there are no adjustments for contrast,
brightness range, or contrast range. Use the brightness controls on the control panel to set the
brightness.
➤ To adjust the monitor brightness
Do either of the following to adjust the brightness:
• To increase the brightness, press F12.
• To decrease the brightness, press F11.
Positioning
the Monitor
You can adjust the position of the monitor to suit different operating positions and operator
heights. The monitor can be tilted up and down, swiveled left and right. To position the monitor,
grasp it by the sides and adjust the tilt and swivel to suit the operator.