![](http://pdfasset.owneriq.net/9/c0/9c0a9f78-ca01-466c-944f-89baedba3395/9c0a9f78-ca01-466c-944f-89baedba3395-bgc2.png)
Connection over local loopFigure A-3:
A
C
D
E
R1
R3
R2
B
A. PC
B. Signal converter
C. Any combination of resistors R1, R2, and R3 as necessary to meet HART communication resistance requirements
D. DCS or PLC
E. Transmitter
Note
This figure shows a serial port connection. USB connections are also supported.
4. To connect over a HART multidrop network:
a. Attach the leads from the signal converter to any point on the network.
b. Add resistance as necessary.
Important
HART/Bell 202 connections require a voltage drop of 1 VDC. To achieve this, add
resistance of 250–600 Ω to the connection.
Using ProLink II with the transmitter
186 Micro Motion
®
Model 1500 Transmitters with Analog Outputs