Filter
Top Products
Configuration and Use Manual 51
Operation AppendicesMaintenance and TroubleshootingCommissioning
Chapter 5
Configuring Operational Parameters
5.1 Overview
The operational parameters control the behavior of the transmitter and flowmeter system. The
following parameters can be configured:
• Display parameters – see Section 5.2
• Fault handling parameters – see Section 5.3
In addition, this chapter provides information on sensor parameters (see Section 5.4) and device
parameters (see Section 5.5). These parameters do not affect measurement or operation, but may be
useful for administration.
Before beginning configuration, ensure that you have made an administrative connection to the
transmitter and that you are complying with all applicable safety requirements.
5.2 Configuring the display
You can configure a variety of parameters to control display behavior and operator actions at the
display.
5.2.1 Update period
The Update Period parameter controls how often the display is refreshed with current data. The
default is 200 milliseconds; the range is 100 milliseconds to 10,000 milliseconds (10 seconds).
Configuration
To configure Update Period:
• Using the Communicator, select
Detailed Setup > Display Setup.
• Using ProLink II, click ProLink > Configuration > Display.
• Using the display, see Figure 2-14.
5.2.2 Display language
The display language can be set to English, French, German, or Spanish. Other languages may be
available, depending on date of purchase.
Configuration
To configure the display language:
• Using the Communicator, select
Detailed Setup > Display Setup.
• Using ProLink II, click ProLink > Configuration > Display.
• Using the display, see Figure 2-14.