Filter
Top Products
Configuration and Use Manual 41
Configuring Process Measurement
Operation AppendicesMaintenance and TroubleshootingCommissioning
Configuration
To configure the volume flow measurement unit:
• Using the Communicator, select
Detailed Setup > Config Fld Dev Var > Flow.
• Using ProLink II, click
ProLink > Configuration > Flow.
• Using the display, see Figure 2-13.
4.6 Describing gas properties for GSV flow measurement
You must use ProLink II to describe the properties of your gas. To describe the properties of your gas:
1. Click
ProLink > Configure > Flow.
2. If you know the standard density of your gas (density at reference conditions), enter it on this
panel, in g/cm3, and click
Next.
Table 4-5 Volume flow measurement units – Gas
Volume flow unit
Display Communicator ProLink II Unit description
NM3/S Not available Nm3/sec Normal cubic meters per second
NM3/MN Not available Nm3/min Normal cubic meters per minute
NM3/H Not available Nm3/hr Normal cubic meters per hour
NM3/D Not available Nm3/day Normal cubic meters per day
NLPS Not available NLPS Normal liter per second
NLPM Not available NLPM Normal liter per minute
NLPH Not available NLPH Normal liter per hour
NLPD Not available NLPD Normal liter per day
SCFS Not available SCFS Standard cubic feet per second
SCFM Not available SCFM Standard cubic feet per minute
SCFH Not available SCFH Standard cubic feet per hour
SCFD Not available SCFD Standard cubic feet per day
SM3/S Not available Sm3/S Standard cubic meters per second
SM3/MN Not available Sm3/min Standard cubic meters per minute
SM3/H Not available Sm3/hr Standard cubic meters per hour
SM3/D Not available Sm3/day Standard cubic meters per day
SLPS Not available SLPS Standard liter per second
SLPM Not available SLPM Standard liter per minute
SLPH Not available SLPH Standard liter per hour
SLPD Not available SLPD Standard liter per day
SPECL Spcl special Special unit (see Section 4.6.2)