Filter
Top Products
14 The Tool Compensation
93
Fig. 14.5.2-4
Fig. 14.5.2-5
Going around the outside of a corner at an acute angle, 0°#"<90°
Special instances of offset mode:
If zero displacement is programmed (or such is obtained) in the selected plane in a block in offset
mode, a perpendicular vector will be positioned to the end point of the previous interpolation, the
length of the vector will be equal to the radius compensation. Instances of this kind should be
handled with caution because of the hazards of inadvertent undercutting or distortions (in the case of
a circle).
For example:
...G91 G17 G42...
N110 G1 X40 Y50
N120 X0
N130 X90
N140 X50 Y-20
...