Filter
Top Products
8 The Reference Point
54
Fig. 8.3-1
taken into account in the new coordinate system.
In the second phase it will move from the intermediate point to the point v defined in instruction G29.
If coordinate v has an incremental value, the displacement will be measured from the intermediate
point.
When the cutter compensation is set up, it will move to the end point by taking into account the
compensation vector.
A non-modal code.
An example of using G30 and G29:
...
G90
...
G30 P1 X500 Y200
G29 X700 Y150
...
...