Filter
Top Products
Configuring MultiDSP Cards (MAX TNT, APX 8000)
Configuring a MultiDSP card
APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide Preliminary May 9, 2000 6-7
• Verifying that all other configurations associated with the MultiDSP services have been
performed. For example, for VoIP MultiDSP support, all required configurations for VoIP,
real-time fax (optional), and other desired MultiVoice features must also be performed.
• Adding support for an additional MultiDSP service, if necessary.
Verifying that MultiDSP services are enabled
The Base profile is a read-only, system-wide profile that displays enabled features, network
interfaces, and system information. Included in the Base profile are the MultiDSP services.
The Base profile indicates which MultiDSP services are currently enabled (licensed). Because
the MultiDSP modem function does not require a software license, no modem-related
parameter appears in the Base profile.
Display the Base Profile to verify that desired services are licensed on the unit. Use the get
base command to view the profile.
The following Base profile parameters relevant to the MultiDSP card. Verify that the
appropriate services are supported for your MultiDSP applications.
The following example shows relevant Base profile parameters and values for a unit installed
with a 48-port MultiDSP card that supports modem calls, digital HDLC calls, and PHS PIAFS
1.0 and PIAFS 2.0 calls (but not PIAFS 2.1 calls):
admin> get base
...
data-call-enabled = yes
...
phs-2-1-support = no
Base profile parameter Value if supported
Data-Call-Enabled Yes if the unit supports data calls over ISDN (digital) lines.
The parameter is also used by Series56 and Hybrid Access
(HDLC) cards.
R2-Signaling-Enabled Yes for R2 signaling support.
SS7-ASG Yes for ASGCP SS7 IMT signaling support.
XCOM-SS7 Yes for IPDC SS7 IMT signaling support.
V110-Enabled Enabled if V.110 software is licensed on the unit.
PHS-Support Yes if Personal Handyphone System PIAFS 1.0, PIAFS 2.0
support is licensed on the unit. For PIAFS 2.1 support, the
PHS-2-1-Support parameter must also be enabled by a
software license.
PHS-2-1-Support Yes if PIAFS 2.1 support is licensed on the unit. The
PHS-Support parameter must also be enabled by a software
license. (The two PHS licenses are also available bundled
into one package.)
VoIP-Enabled Yes if VoIP is enabled by a software license.
RTFax-Enabled Yes if real-time fax (T.38) is licensed. For real-time fax
support, the VoIP-Enabled parameter must also be enabled
by a separate software license.