Filter
Top Products
Configuring Unchannelized DS3 Cards (MAX TNT, DSLTNT)
Configuring the UDS3 physical link
APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide Preliminary May 9, 2000 13-3
By default, each unchannelized DS3 line is disabled. When the DS3 interface is disabled, it
transmits the DS3 Idle Signal to the far end.
To assign the line a name and enable it, proceed as in the following example:
admin> read uds3 {1 2 1}
UDS3/{ shelf-1 slot-2 1 } read
admin> set name = uds3-LA
admin> set enabled = yes
admin> write
UDS3/{ shelf-1 slot-2 1 } written
The default settings for the line-type and line-coding parameters are used because the
unchannelized DS3 slot card (UDS3) supports only C-bit-parity framing and B3ZS encoding.
Consult the APX 8000/MAX TNT/DSLTNT Frame Relay Configuration Guide for detailed
information about configuring the Frame Relay portion of the connection.